1 ------------------------------------------------------------------------------- |
1 ------------------------------------------------------------------------------- |
2 UAP Common eXtensions - UCX |
2 UAP Common Extensions - UCX |
3 ------------------------------------------------------------------------------- |
3 ------------------------------------------------------------------------------- |
4 |
4 |
5 0. Table of Contents: |
5 0. Table of Contents: |
6 |
6 |
7 1. Introduction ........................................................ 15 |
7 1. Introduction ........................................................ 15 |
8 2. Build ............................................................... 26 |
8 2. Build ............................................................... 26 |
9 3. Install ............................................................. 58 |
9 3. Install ............................................................. 37 |
10 4. Documentation ....................................................... 71 |
10 4. Documentation ....................................................... 50 |
11 5. Contact ............................................................. 84 |
11 5. Contact ............................................................. 63 |
12 6. License ............................................................. 90 |
12 6. License ............................................................. 69 |
13 |
13 |
14 |
14 |
15 1. Introduction |
15 1. Introduction |
16 --------------- |
16 --------------- |
17 |
17 |
24 |
24 |
25 |
25 |
26 2. Build |
26 2. Build |
27 -------- |
27 -------- |
28 |
28 |
29 Untar the source archive and run |
29 Untar the source archive and simply run |
30 |
30 |
31 make CONF=<yourconfig> |
31 ./configure && make |
32 |
32 |
33 If you are going to use gcc, then simply run |
33 If you want to verify your build, you may then run |
34 |
34 |
35 make |
35 make check |
36 |
|
37 The available configurations are clang, gcc, mingw, osx and suncc. |
|
38 |
|
39 The build files are placed into a build subdirectory, which is created if it |
|
40 does not exists. |
|
41 |
|
42 The default target builds optimized binaries. Use the debug target by running |
|
43 |
|
44 make debug CONF=<yourconfig> |
|
45 |
|
46 to disable optimization and enable debug symbols. |
|
47 |
|
48 If you want to test your build either run |
|
49 |
|
50 make run CONF=<yourconfig> |
|
51 |
|
52 or |
|
53 |
|
54 make run-debug CONF=<yourconfig> |
|
55 |
|
56 Again, you can omit the CONF parameter, when using the gcc. |
|
57 |
36 |
58 3. Install |
37 3. Install |
59 ---------- |
38 ---------- |
60 |
39 |
61 Build the binaries as described in chapter two. Then install UCX, by running |
40 Build the binaries as described above. Then install UCX, by running |
62 |
41 |
63 make install |
42 make install |
64 |
43 |
65 or |
44 or |
66 |
45 |
67 make install PREFIX=<install_dir> |
46 make install PREFIX=<install_dir> |
68 |
47 |
69 The default prefix is /usr/local. |
48 The default prefix is /usr/local and will require privileged access. |
70 |
49 |
71 4. Documentation |
50 4. Documentation |
72 ---------------- |
51 ---------------- |
73 |
52 |
74 Documentation is available at: |
53 Documentation is available at: |